- In-wall sub, totally hidden from view
- Dual 8" woofers and 380-watt outboard SA-380 amplifier
- Back box in-wall enclosure available (Required for THX performance)
- This is the solution to Unbelievable Bass using ZERO floor space
- Servo-control distortion reduction circuitry in SA-380 amplifier
Trouble viewing the links above? Download the latest version of Adobe Reader.
IWTS-8e Subwoofer Module Specifications
||(2) 8” High output woofers,|
Coated Composite Molded Graphite cones
with 8 lbs. motor assemblies
||20Hz - 100Hz ± 3dB (typical, in room)|
||Single 102dB, Dual 105dB (3000 cu. ft. space)|
|Dimensions (H x W x D)
||Woofer Module: 19-13/16” x 10-5/8” x 3”|
IN-BOX-8 SUB Enclosure: 81” x 14” x 3-1/2”
SA-380 Monoblock Subwoofer Amplifier Specifications
||380 watts, 4 ohms|
|Signal to Noise Ratio
||<97dB full power |
|Total Harmonic Distortion
||0.05% @ full output|
|Low Level Input Sensitivity
||250mw full output, 100Hz|
|High Level Input Impedance
|Power Supply Storage
|Peak Output Stage Current
||40 amps |
||2“ 1-.25U (50mm)|
||12.5" (330mm) including knobs and rear terminals|
Atlantic Technology reserves the right to change specifications or appearance at any time without notice.
IWTS-8e Subwoofer Assembly
Each braced MDF enclosure accommodates a dual 8-inch long-throw woofer assembly, providing roughly the same cone area as a single 12-inch woofer, but with better control and lower distortion. These unique drivers sport a stiff and well-damped Coated Composite Molded Graphite cone, with an unusually strong cone-reinforcing concave dust cap. The vented eight-pound motor and 1.5-inch vented multi-layer voice coil are more typical of those found on a 15-inch driver. Additionally, the baffle is treated with Atlantic's exclusive Resonance Damping Treatment (RDT) to reduce unwanted baffle resonace for clear, articulate bass.
SA-380 monoblock amplifier
The SA-380 iis capable of delivering 380 rock-solid RMS watts for the reproduction of exciting, authoritative theater bass. Its linear power discrete Class G circuitry delivers 380 watts RMS and 550 watts short-term peak power. The design uses audiophile-grade components, including a high-current custom-wound low-hum toroidal transformer. Class G design means the power supply is in dual mode in operation, one for long-term operation, and one for short-term very high power peaks.
Servo-control circuitry--This circuit monitors the woofers' performance. If the servo control detects driver distortion it immediately corrects it, resulting in very high output levels at unusually low distortion levels. A 2-position phase switch and THX-reference click-stop on the level control make operation easy and effective.
IN-BOX-8e sub enclosures
Each Atlantic Technology Sub 8 ein-wall enclosure is 81 inches tall, 14-1/2-inches wide and 3-1/2 inches deep, with a 17-13/16 x 9-3/8 inch cut-out dimension for the woofer module. Designed for installation before the sheet rock goes on, only a discrete grille is visible at knee-level in the room. While the grill extends 1-1/2 inches into the room to accommodate the high excursion of the woofers, its smoothly radiused compound curves make it very inconspicuous.